Should I use Bondo to repair a half inch deep by half inch diameter hole in a wooden cabinet?

40DD. You may want to go to a professional for fitting to find a good bra for you, since you might need extra support with such a large difference between...

Listen to the song over and over and over again. Start to sing it. Take 15 to 20 minutes to do something else, something like taking a shower or drawing....

This is fine. You mostly want the wiring to be thin so that it's more pliable for making the coils so as long as you're still able to do that...

If you know the diameter of a circle that touches the corners of the hexagon, this is easy. Halve the diameter to get the length of your hexagon's sides. The...

Yes, it should not be lumpy at all, Get new Bondo and new hardener, mix some up, and you will see how it is supposed to be. Close the lid...

If we assume that the hole is cylindrical, the volume would be r²πh, where the radius (r) is half the diameter 16/2 = 8ft and the height (h) is 20ft....

Find the volume in cubic meters (πr²h). Multiply that number by 1,000.

They most likely wont close completely, but they will shrink to about a 12 if you stretched correctly.

I wouldn't use schedule 40 for your particular application. I would use schedule 80; it is much more rigid and is very tough. You can drive heavy equipment or commercial...

It is highly unlikely that a PVC pipe will break under such a load; however, it will bend significantly. To avoid this, you can also check out metal fencing pipes...